Porter-cable 6641 Instrukcja Użytkownika

Double InsulatedPortable ElectricScrewdriversInstructionmanualThe Model and Serial No. plate is located on the mainhousing of the tool. Record these n

10There is a small spring in the end of the power unit spindle shaft. Becareful not to lose this spring. Note condition of 3-jaw clutch faces on power

11ACCESSORIESA complete line of accessories is available from your Porter-Cable •Delta Supplier, Porter-Cable • Delta Factory Service Centers, and Por

12PORTER-CABLE LIMITEDONE YEAR WARRANTYPorter-Cable warrants its Professional Power Tools for a period of one year from the date of originalpurchase.

The following are trademarks of PORTER-CABLE •DELTA (Las siguientes son marcas registradas de PORTER-CABLE •DELTA S.A.) (Lesmarques suivantes sont des

2WARNING: SOME DUST CREATED BY POWER SANDING, SAWING,GRINDING, DRILLING, AND OTHER CONSTRUCTION ACTIVITIEScontains chemicals known to cause cancer, bi

32. Dress properly. Do not wear loose clothing or jewelry. Contain longhair. Keep your hair, clothing, and gloves away from moving parts. Looseclothes

SPECIFIC SAFETY RULES AND SYMBOLS FORSCREWDRIVERS1. VERIFY direction of rotation of screwdriver is correct for operation to beperformed before startin

5MOTORMany Porter-Cable tools will operate on either D.C., or single phase 25 to 60cycle A.C. current and voltage within plus or minus 5 percent of th

61. Make sure power circuit voltage is the same as that shown on thespecification plate of screwdriver. Connect screwdriver to power circuit.2. Squeez

73. Release adjusting collar being sure that the depressions in the collarengage the projections on the clutch housing.4. Drive a test fastener in a p

8TO CHANGE BIT HOLDER – MODELS 6640, 66451. CAUTION: DISCONNECT TOOL FROM POWER SOURCE.2. Twist and pull the aluminum nosepiece (A), Fig. 4, out of th

9CAUTION: DO NOT EXERT PRESSURE ON SCREW WHILE DOING THIS. 4. Place end of screw in desired location and remove fingers. 5. Apply forward pressure to