Porter-cable 17-990X Instrukcja Użytkownika

INSTRUCTION MANUAL16½" Variable Speed Drill Press(Model 17-925)(Model 17-990X)PART NO. 909592 - 03-06-03Copyright © 2003Delta MachineryTo learn m

1011. IMPORTANT: Make certain the spindle taper (Q) Fig.15, and tapered hole in chuck (R) are clean and free ofany grease, lacquer or rust preventive

1115. Thread the two speed changing levers (W) Fig. 18,into the speed changing hub as shown.16. Thread the speed range changing lever (X) Fig. 19,into

12PERMANENT MOUNTINGIf your drill press is to be used in a permanent location, the drill press base must be secured to the supporting surfacewith fast

13OPERATING CONTROLS AND ADJUSTMENTSSTARTING AND STOPPINGDRILL PRESSThe power switch is located at the front of the drill presshead. To turn the machi

14VARIABLE SPEED CONTROLDO NOT turn variable speed pilot wheel handles (A) Fig.28, unless motor is running to avoid putting unnecessarystrain on the d

15Fig. 33DAEBCADJUSTING SPINDLERETURN SPRINGThe spindle is automatically returned to its upper mostposition upon release of the handle. It is recommen

16OPERATIONSFig. 34Your drill press is to be used with drill bits with a shank of1/2" or less in diameter. The following will give theinexperienc

17BORING IN WOODTwist drills, although intended for metal drilling, may also be used for boring holes in wood. However, machine spur bitsare generally

18MAINTENANCELUBRICATIONFig. 36The variable speed pulleys and the speed range shifter mechanism should be oiled weekly with a few drops of lightmachin

19Two Year Limited WarrantyDelta will repair or replace, at its expense and at its option, any Delta machine, machine part, or machine accessory which

2Woodworking can be dangerous if safe and proper operating procedures are not followed. As with all machinery, thereare certain hazards involved with

The following are trademarks of PORTER-CABLE·DELTA (Las siguientes son marcas registradas de PORTER-CABLE S.A.): Auto-Set®,BAMMER®, B.O.S.S.®, Builder

3ADDITIONAL SAFETY RULES FOR DRILL PRESSESFAILURE TO FOLLOW THESE RULES MAY RESULT IN SERIOUS PERSONAL INJURY.SAVE THESE INSTRUCTIONS. Refer to them o

4A separate electrical circuit should be used for your machines. This circuit should not be less than #12 wire and shouldbe protected with a 20 Amp ti

Use proper extension cords. Make sureyour extension cord is in good condition and is a 3-wireextension cord which has a 3-prong grounding typeplug and

6DRILL PRESS PARTS1 - Drill Press head2 - Column and table raising rack3 - Table/column bracket4 - Lock lever for column bracket 1/2-13x1-1/2"5 -

7ASSEMBLYFOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL THEMACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE

84. Slide raising rack (F) Fig. 7 and table bracket (I) ontodrill press column, as shown. Make sure bottom ofraising rack (F) Fig. 8, is engaged with

97. Thread clamp handle (M) Fig. 11, into hole in rear oftable bracket, as shown.10. Place the drill press head (N) Fig. 14, onto thecolumn as far as