Porter-cable BN200V12 Instrukcja Użytkownika

CORDLESS BRADNAILERInstructionmanualThe Model and Serial No. plate is located on themagazine of the tool. Record these numbers in thespaces below and

OPERATIONUSING THE TOOLComplete all steps of PREPARING THE TOOL before using the tool.To fasten, move switch (A) Fig. 19 to desired position, grip too

11WARNING: Disconnect tool from air supply and/or remove batterybefore performing maintenance, clearing a jammed fastener, leavingwork area, moving to

12CLEARING A JAMMED FASTENER1. WARNING: Disconnect tool from air supply and/or remove battery.2. Open magazine and remove any remaining fasteners (see

13BATTERY OPERATIONCHARGING THE BATTERY PACK GENERAL Before using your cordless Nailer for the first time, the battery pack shouldbe fully charged. If

14DIAGNOSTICSThe Porter-Cable Charger is equipped with a diagnostic system thatautomatically checks the battery pack each time a pack is inserted into

MAINTENANCECLEAN AND INSPECT DAILYWARNING: Disconnect tool from air supply and/or remove batterybefore cleaning and inspection. Correct all problems b

TROUBLESHOOTINGWARNING: Disconnect tool from air supply and/or remove batterybefore performing any Service Procedure.SYMPTOM PROBLEMS SOLUTIONS1. Air

17PORTER-CABLE LIMITED ONE YEAR WARRANTYPorter-Cable warrants its nailing and stapling tools for a period of one year from the date of originalpurchas

18NOTES901891 - 08-31-01.qxd 2/13/02 11:53 AM Page 18

The following are trademarks of PORTER-CABLE •DELTA (Las siguientes son marcas registradas de PORTER-CABLE •DELTA S.A.) (Lesmarques suivantes sont des

GENERAL SAFETY RULESWARNING: When using pneumatic tools, basic safety precautionsshould always be followed to reduce the risk of personal injury. Fail

39. THE TOOL COMES EQUIPPED WITHTWIN POWER SOURCE TECHNOLOGY(TPS)™. DISCONNECT TOOL FROM AIRSUPPLY HOSE AND/OR REMOVEBATTERY before doing tool mainte

417. REMOVE FINGER FROM TRIGGERwhen not driving fasteners. Never carry toolwith finger on trigger. Fig. 10.18. DON’T OVERREACH. Keep properfooting and

5WORK AREA1. Keep your work area clean and well lit. Cluttered benches and darkareas invite accidents.2. Do not operate power tools in explosive atmos

67. Check for misalignment or binding of moving parts, breakage ofparts, and any other condition that may affect the tool’s operation. Ifdamaged, have

72. Before using a battery charger, read all instructions and cautionarymarkings on (1) battery charger, (2) battery pack, and (3) product usingbatter

819. Dispose of expended batteries properly.Porter-Cable Battery Packs contain rechargeable,nickel-cadmium batteries. These batteries must berecycled

9All compressed air contains moisture and other contaminates that aredetrimental to internal components of the tool. When using external air, an airli